Capacity                                      14000 lbs

Power supply                               230 VAC 1Ph 50/60 Hz

Weight                                         6387 lbs

Width Between Runways            38 inch

4 Wheel Alignment Wheelbase   88 - 155 inch

2 Wheel Alignment Wheelbase   180 inch / 165 inch

Console Dimensions DxWxH      16.5 x 14.125 x 45.755 inch

Air Supply Requirements             90 - 120 Psi

Overall Length                             270 inch / 256.19 inch

Service Wheelbase                     194 inch / 179 inch

Overall Width                               92.5 inch

Runway Width                             26 inch

Hofmann 14k Scissor

Hofmann® Scissor Alignment Lifts are easy to operate, provide increased accessibility to alignment adjustment areas and are easy to load. Space saving design allows for up to five scissor lifts to fit into the same operating space as four 4-post lifts.

Locked and Lighted models provide productivity enhancements while allowing the technician to perform critical tasks while minimizing alignment process operations, by illuminating both inspection and adjustment areas and by sequencing the locking of alignment plates.

Part Number:  

STANDARD BAY SURFACE MOUNT WITH LIGHTS AND LOCKS - EELR789APKG

STANDARD BAY FLUSH MOUNT WITH LIGHTS AND LOCKS - EELR790APKG

SHORT BAY SURFACE MOUNT WITH LIGHTS AND LOCKS - EELR785APKG

SHORT BAY FLUSH MOUNT WITH LIGHTS AND LOCKS - EELR786APKG

True Task Lighting System (Lights and Locks Models)

Patented auto on/off light feature ensures no power when operating in the hazard zone

 

Patented light mounting position optimizes viewing angle, illuminating key inspection and adjustment areas

 

Approved for use in Class 1 Division 1 environments for both surface and flush mount models

Additional Features

Maintenance reduced rear slip plates use oversized, encapsulated bearings that roll upward to protect against environment debris

 

Four hydraulic cylinders in a cross aligned arrangement provide secure lifting power and added safety

 

Approach ramps are equipped with end sliders to minimize noise and reduce floor damage

 

Adjustable maximum lift height suits locations with low ceilings

 

Safety systems include:
- Mechanical locking with pneumatic safety lock release from the control console
- Flow sensing valves within the hydraulic control circuit
- Redundant hydraulic safety system with cross aligned hydraulic circuits

 

On-board Filter/Regulator/Lubricator (FRL) provides clean and lubricated air to help reduce maintenance and protect pneumatic systems

 

Models equipped with locks and lights;
- have ease locking control activation from the lift console to reduce walking and effort from resetting alignment pins in plates
- include locking components made from corrosion resistant materials
- illuminate alignment adjustment and calibration areas
- front LEDs are mounted in the front turnplate base to easily accommodate varying vehicle wheel tracks
- rear LEDs are strategically positioned on the rear slip plates

 

All models have been tested and validated by an independent third party to the ANSI/ALI automotive lift standard, ALCTV-2011

  • Facebook
  • Instagram

© 2020 Timco Hoist Services 1210582AB LTD

Proudly created with Wix.com